With the approach of the winter LF season it was time to look at building an LF receive antenna to put on the apartment balcony. My attention was drawn to the design by wa1zms
A Simple Loop Antenna for 500 kHz. It looked straightforward to build. The half inch wood was available at the local hardware store. The hard question was how to cross the wood at the centre. Luckily Bob WA5YWC stepped in and milled the crossover portion to be a snug fit, solving that issue. Each arm had 8 holes (for the 8 turns of wire) spaced at 0.5". The two arms were secured with a brass screw to allow dismantling
I had found some 10/46 Litz wire on ebay. It soon became very apparent that this was too fragile to use as it snagged and broke with ease. A further internet search revealed a supply of the more robust 10/26 Litz wire from
scotts electronic Parts It was not cheap but it would do the job. The wire was mounted on the frame easily and terminated with two brass nails. I measured the inducance and found it was 65uH, meaning around 1700pF would be needed to resonate the loop at around 475kHz. This value was soldered across the brass pins.
A visit to the local emporium produced all the components for the preamp including a box and stripboard. This was assembled and attached to the mast with adhesive backed velcro and a 9V battery attached. . I hooked it up to the ANAN-10 and took a listen around 475kHz. but I noticed that the PowerSDR software was indicating an A/D overload. The preamp was acting as a wideband power oscillator! I re-examined the wiring finding a couple of extra short circuits which were fixed. Reconnecting it to the receiver I could hear the WG2XIQ on 475.7kHz and the antenna showed the expected very sharp nulls
131028 0152 25 -7 0.3 0.475663 WG2XIQ EM12 30
131028 0156 24 -8 0.5 0.475663 WG2XIQ EM12 30
131028 0200 23 -9 -2.0 0.475663 WG2XIQ EM12 30
131028 0208 10 -21 -1.4 0.475663 WG2XIQ EM12 30
131028 0212 10 -21 -0.3 0.475663 WG2XIQ EM12 30
131028 0216 11 -20 -0.2 0.475664 WG2XIQ EM12 30
